EMC/x>1 Analysis Task List Updated September 23, 2005 1) Detector (and other) calibrations a) HMS/SOS gas cerenkov (done) b) HMS/SOS calorimeter (done) c) HMS/SOS time-of-flight (done) d) HMS/SOS drift maps (done) e) Optimize tracking parameters (not done) f) Check effect of chisquare vs. scin track selection (done) f.i) Check multiple tracks at low rates (done - no problem) g) BCM calibration global fit (done) 2) Target thickness a) Find beam/target offsets (done) b) He3/He4 response to beam trips (done) c) Run-to-run He4/He3 target density (done) d) Dummy-target can thickness calculation (done) 3) Efficiencies a) 3/4 Efficiency - need to correct across acceptance? (done) a.i) Find smart way to monitor stability throughout run (done - stable) b) Tracking efficiency studies c) Calorimeter efficiency - problems because of hsshtrk jump? (done) d) Cerenkov efficiency (done) e) Pion rejection/contamination studies (done) f) Overall trigger efficiency (including PID detectors) (done - need x-dep. correction) g) Electronic dead time vs. rate study h) Computer dead time study (partial checks done) i) Run-to-run yield checks j) Make giant efficiency table? (always in progress) 4) Offsets (Dave, in progress) a) Check HMS angle/P offsets with singles delta=0 elastics (done) b) Check with production data c) Check 4He(e,e'p)3H and 3He(e,e'p)2H data - check xsec? d) Check "corrected singles" taken during pionCT? 5) Other/optics a) Improved HMS correction? (Tanja and Dave) b) Luminosity scan re-analysis - carbon boiling! VERY IMPORTANT - high priority. c) ENGINE error parsing d) Logbook "significant event" scan (done) 6) Normalization checks a) Check elastic cross yields vs. simc b) Check elastic xsec extracted from stand-alone code? 7) Cross section/target ratio extraction a) Generate acceptance corrections b) Implement bin-centering corrections c) Radiative corrections d) Coulomb corrections e) Charge-symmetric backgrounds (done)