Privacy and Security Notice

Personal Web Links - John Hansknecht

Yahoo mail Webmail Staff Search

Elog Page Jlab Insight Page Polarized Source Web Page EH&S Manual

Credit Card   TimeCard Deltek

Requisition System (Maximo) WebStock Property Mgmt

Items in Receiving for me My Purchase Requisitions

LaserSafetySystems.com  web site

 Awesome RLC calculators

Other Electronics calculators

dBm to Watt Conversion Calculator

 dBm mW  W

dBm = log10 (mW)*10
mW =10^(dBm/10)

Polarization Calculator
Pass laser beam through a spinning waveplate followed by a linear polarizer and photodiode.
The resulting intensity is displayed on an oscilloscope.
Enter Maximum Value from Sine wave here
Enter Minimum Value from Sine wave here

  Calculated %  Circular Polarization               %Circular Polarization = 200*(sqrt(min*max)/min+max)
  Calculated %  Linear polarization                  %Linear polarization = (max-min)/(max+min)

Some tunes:

Capacitor Charge (Joules) = 1/2C*V²  

LM317 Voltage Regulator Calculator

The basic LM317 circuit. See the datasheet for advice
on adding capacitors and other enhancements.

Enter the required output voltage and value of the R1 resistor to calculate the R2 resistor. Then use the nearest available value (listed at the bottom of the page) or a smaller resistor and series trim-pot for greater accuracy. Maximum output is 37V.

R1 can be changed but should be kept in the range 100-1000 ohms. The regulator should have a minimum load of 10mA for the worst-case specified accuracy; the 240 ohm resistor commonly used gives a 5mA loading which is usually OK.

The second calculator can be used to see the calculated voltage resulting from your stock value resistors. Resistor values must be entered in ohms, '1k' won't work. Sorry.

(Due to voltage losses in the LM317 regulator chip, the input voltage should be at least 2V more than the required output voltage.)

Output Voltage

R1 resistor

R2 resistor

R1 resistor

R2 resistor

Output Voltage

Why is my output voltage a bit off?

The formula used to calculate the regulated voltage is:

V_out = 1.25(1 + R2/R1)

However,

• The Reference Voltage is only nominally 1.25V and for different components it can vary from 1.20–1.30V; so with a 12V aim, the end result will be 12V ±0.5V.
• The resistors won't be exactly what they say. The cheaper gold-banded are ±5%, brown-banded metal film not much more expensive and ±1%.
• There's a small error term Iq * R2 to add to the result. Iq, the Adjustment pin current, is typically only 50µA (0.00005), so it doesn't usually make much difference compared to the two factors above; only 5mV if R2=1k.

If you need high accuracy, use an adjustable trimpot for all or part of R2.

E24 resistor series

The E24 series is widely available and goes up in roughly 10% steps as below:

10 ohms, 11, 12, 13, 15, 16, 18, 20, 22, 24, 27, 30, 33, 36, 39, 43, 47, 51, 56, 62, 68, 75, 82, 91...

and decades of the above, eg 120 ohms, 4,700 ohms (4.7k).

Photos by Bob May.  Summer 2005.  North Carolina's Outer Banks (Good times)