| 1 |
|
Log on to ITS01 and bring up the MEDM screen cavemenu.adl |
| 2 |
|
Turn Laser on to warm up. |
| 3 |
|
Verify shutter closed on EPICs control screen. |
| 4 |
|
Load Saved setting using menu button on lower right side of EPICs control
screen. |
| 5 |
|
Cycle hysteresis to all lenes and the Dipole. |
| 6 |
|
Make Sure all Safety Interlocks engaged |
|
a |
Water Flow to Beam Dump is ON |
|
b |
High Voltage Shroud in Place and interlocks at both ends of High Voltage
Cable in place. |
|
c |
The Dipole Magnet in energized. |
|
d |
Cave is Swept and door interlocks are engaged |
|
e |
On EPICs control screen, HV button is off. |
| 7 |
|
Push Start button on Interlock Chassis (located in rack to the right
of monitors) |
| 8 |
|
Turn the Glassman HV Supply on and verify current is set at 10mA and
Voltage is dialed to Zero. |
| 9 |
|
With either Shutter closed or the Power Meter in, Press the EPICs HV
On Button. |
| 10 |
|
Slowly dial the voltage up on the Glassman HV Supply. Using the
volt meter in the rack to the left adjust voltage to 8 VDC. |
Go
to the Electrical Schematics Page