Archived Messages for CLAS_DRIFT_CHAMBERS_1997@cebaf.gov: Re: Reg. 2,3 geometries

Re: Reg. 2,3 geometries

MAC MESTAYER (MESTAYER@cebaf.gov)
Mon, 20 Oct 1997 16:45:44 -0500 (EST)

Messages sorted by: [ date ][ thread ][ subject ][ author ]
Next message: Richard Thompson: "DC meeting minutes"
Previous message: Richard Thompson: "DC meeting->change of time"

In answer to Rob's question, "is the Reg. 2,3 geom. correct within RECSIS?"
The answer is "yes", I think. The same code which was used to calculate
wire positions for the endplate manufacturing spec. sheets is used in
RECSIS now.
regards, Mac

Next message: Richard Thompson: "DC meeting minutes"
Previous message: Richard Thompson: "DC meeting->change of time"