Log in as "primex" to clon10 and type "start_daq". Press "Connect", "Configure", select "PRODUCTION" (and click OK), "Download", "Prestart" (fill out the prestart window), and finally click "Run".
Log in as "primex" to any clon machine and type "phaseEditor.tcl". Use the window to edit the phase information. To edit the trigger configuration for any given phase, click the "Edit..." button of that phase. The triggers are defined as follows:
We usually run pev on clon00 with the display on the monitor marked "CLON04:0.2". To start pev, open a window in the CLON04:0.2 display and ssh into clon00 as "primex". Type "pev ET:primex:PEV". Once the window opens, press the "Continuous Events" button to start displaying events.
If the DAQ system is running and beam is in the hall, but no events are being displayed, then you probably need to start the et2et program on clon10. To do this, log into clon10 as "primex" and type "et2et ET:primex:ET2ET"Log in as "primex" to clon10 and type "hycal_monitor ET:primex"
There are 3 ways. All must be done from the same machine and account that hycal_monitor is running on (probably primex on clon10).
Log in as "primex" to any of the clons. cd into the "tmp" directory. Start up root. Type ".L gains.C" (note the dot before the L). Type "Go()". Finally, type "Loop("W234")" to start displaying the histogram for W234. To stop it and move to the next detector, hit control-C to break the loop, hit return a few times, and execute Loop again.