\addvspace {10\p@ }
\contentsline {figure}{\numberline {1.1}{\ignorespaces The G0 cryogenic target loop}}{9}
\addvspace {10\p@ }
\contentsline {figure}{\numberline {2.1}{\ignorespaces A layout of the target motion mechanism, courtesy of Thermionics}}{15}
\contentsline {figure}{\numberline {2.2}{\ignorespaces The dummy target setup with the big hole target on the beam left, followed by the small hole target, and the radiator hole target on the beam right. The aluminum flyswatter target is shown in beam in front of the hydrogen cell.}}{18}
\contentsline {figure}{\numberline {2.3}{\ignorespaces The upstream Tungsten radiator as seen through the radiator hole on the frame.}}{19}
\addvspace {10\p@ }
\contentsline {figure}{\numberline {3.1}{\ignorespaces The main G0-target GUI: /group/gzero/g0targ/screens/g0target-main.adl}}{23}
\contentsline {figure}{\numberline {3.2}{\ignorespaces The alarm handler bar}}{26}
\addvspace {10\p@ }
\contentsline {figure}{\numberline {4.1}{\ignorespaces The {\bf HeaterControl} screen}}{32}
\contentsline {figure}{\numberline {4.2}{\ignorespaces The high power heater PID screen}}{33}
\contentsline {figure}{\numberline {4.3}{\ignorespaces The target motion control MEDM screen.}}{37}
\contentsline {figure}{\numberline {4.4}{\ignorespaces The flyswatter motion control box (small grey box) located on the target service module in Hall C. The actuator knob is located just above the box.}}{40}
\addvspace {10\p@ }
\contentsline {figure}{\numberline {5.1}{\ignorespaces The alarm tree for the G0 target}}{47}
\addvspace {10\p@ }
\addvspace {10\p@ }
\addvspace {10\p@ }
\addvspace {10\p@ }
\addvspace {10\p@ }
\addvspace {10\p@ }
\contentsline {figure}{\numberline {D.1}{\ignorespaces Analog inputs screen}}{67}