Privacy and Security Notice
G0-NA-FPD Mounting
June 20th, 02
What is in the clean-room
cabinets ?
Octant mounting :
-
O-rings to put between PMT and housing, and between housing and back
plate
-
pins to maintain mu-metal inside the housing, and to maintain PMT-base
on the housing
-
clips to maintain scintillators on the octant support
-
light guide clamps to maintain light guide on octant support
-
gizmo to center light guide in the middle of the back plate hole
-
3 black plastic wedges to maintain light guides in the middle of the back
plate hole
-
gms fiber caps
-
back plate gms fiber caps
-
sticky foam (to put in between light tigh box side plate and octant support
-
bicron sticky paper (W&M)
-
paper template for light tigh box cover
-
one sheet on herculyte enough for a light tigh box cover (completly new)
-
one sheet on herculyte enough for a light tigh box cover (the prototype
one, can be reused if needed)
PMT's (updated on June 20th, 02)
-
XP2262B : 36
-
housing : 31
-
TRIUMPH bases : 21
-
PMT with bases in housing : all prototypes : ~ 10
-
Si cookies (~100)
-
Si cookie cutter
DAQ :
-
BNC, lemo and HV cables
-
Phillips pulser
-
delays box : 50 ns and 100 ns (Maryland)
-
lecroy,caen, phillips manual
-
connectors bnc and lemo
-
led hoocked on leno or bnc cables
miscellanous :
-
gloves, wipers
-
cords
-
distillated water and isopropanol bottel
-
calculator
-
scintillator and lucite pieces
Not stored in the
cabinets but around them :
-
roll of 320 feet of
rg 213
-
sheets of lead (used
to cover the prototype) -> physics storage building
-
the octant 8 prototype
-
1 complete set of light
guide for scintillator 4
-
Herbert's paddles
-
a set of scintillator
for one octant
-
a roll of teflon (new
08-03)
-
a roll of herculyte
(new 08-03)
Last update
:August, 03
This
page is maintained by : J.
Roche