| Rebooting
the Target IOC, ctd. |
|
|
|
|
|
|
|
|
|
|
|
|
|
| • | Not OK? Then hardware reboot (target IOC) thru |
|||||||||||
| the reboot GUI over at the CODA terminal |
||||||||||||
| • | Put HPH back on PID: |
|||||||||||
| – | Main GUI – Heater Control – check set val is
ok – PID |
|||||||||||
| Enable – Heater Mode PID |
||||||||||||
| • | PID OK? Then flip manual HPH switches back to |
|||||||||||
| “Computer”. Check that PID is “pidding”. |
||||||||||||
| • | Call MCC for beam back. Log event in g0log. |
|||||||||||