| Adjusting
the Heat Load |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| • | Pbeam~270 W at 40 µA, Preserve~50-100 W |
||||||||||||
| • | With beam on, need ~50-100 W on HPH |
||||||||||||
| • | With beam off should have ~350 W on HPH |
||||||||||||
| – | (if off a long time, can reduce) |
||||||||||||
| • | HPH power adjusterd automatically |
||||||||||||
| – | (in PID looking at Tloop |
||||||||||||
| • | To adjust, use JT: |
||||||||||||
| – | Open JT to increase HPH power |
||||||||||||
| – | Close JT to lower HPH power |
||||||||||||